Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 363
IGMP Static Multicast Router Configuration
Table 226 describes the commands used to configure a static multicast router.
Note – When static Mrouters are used, the switch continues learning dynamic Mrouters via IGMP
snooping. However, dynamic Mrouters may not replace static Mrouters. If a dynamic Mrouter has
the same port and VLAN combination as a static Mrouter, the dynamic Mrouter is not learned.
no ip igmp snoop igmpv3 enable
Disables IGMP version 3.
Command mode: Global configuration
show ip igmp snoop igmpv3
Displays the current IGMP v3 Snooping configuration.
Command mode: All except User EXEC
Table 226 IGMP Static Multicast Router Configuration Commands
Command Syntax and Usage
ip igmp mrouter <port alias or number> <VLAN number> <version (1-3)>
Selects a port/VLAN combination on which the static multicast router is connected, and
configures the IGMP version of the multicast router.
Command mode: Global configuration
no ip igmp mrouter <port alias or number> <VLAN number> <version (1-3)>
Removes a static multicast router from the selected port/VLAN combination.
Command mode: Global configuration
clear ip igmp mrouter
Clears all static multicast routers from the switch.
Command mode: Global configuration
show ip igmp mrouter
Displays the current IGMP Static Multicast Router parameters.
Command mode: All except User EXEC
Table 225 IGMP version 3 Configuration Commands
Command Syntax and Usage