Technical data

BLADEOS 6.3 Command Reference
362
 Chapter 4: Configuration Commands BMD00186-B, April 2010
IGMPv3 Configuration
Table 226 describes the commands used to configure IGMP version 3.
default ip igmp snoop
Resets IGMP Snooping parameters to their default values.
Command mode: Global configuration
show ip igmp snoop
Displays the current IGMP Snooping parameters.
Command mode: All
Table 225 IGMP version 3 Configuration Commands
Command Syntax and Usage
ip igmp snoop igmpv3 sources <1-64>
Configures the maximum number of IGMP multicast sources to snoop from within the group
record. Use this command to limit the number of IGMP sources to provide more refined
control. The default value is 8.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 v1v2
Enables or disables snooping on IGMP version 1 and version 2 reports. When disabled, the
switch drops IGMPv1 and IGMPv2 reports. The default value is enabled.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 exclude
Enables or disables snooping on IGMPv3 Exclude Reports. When disabled, the switch
ignores Exclude Reports. The default value is enabled.
Command mode: Global configuration
ip igmp snoop igmpv3 enable
Enables IGMP version 3. The default value is enabled.
Command mode: Global configuration
Table 224 IGMP Snooping Configuration Commands
Command Syntax and Usage