Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 361
[no] ip igmp snoop aggregate
Enables or disables IGMP Membership Report aggregation.
Command mode: Global configuration
ip igmp snoop source-ip <IP address>
Configures the source IP address used as a proxy for IGMP Group Specific Queries.
Command mode: Global configuration
ip igmp snoop vlan <VLAN number>
Adds the selected VLAN(s) to IGMP Snooping.
Command mode: Global configuration
no ip igmp snoop vlan <VLAN number>
Removes the selected VLAN(s) from IGMP Snooping.
Command mode: Global configuration
no ip igmp snoop vlan all
Removes all VLANs from IGMP Snooping.
Command mode: Global configuration
[no] ip igmp snoop vlan <VLAN number> fastleave
Enables or disables Fastleave processing. Fastleave allows the switch to immediately remove
a port from the IGMP port list, if the host sends a Leave message, and the proper conditions
are met. This command is disabled by default.
Command mode: Global configuration
ip igmp snoop enable
Enables IGMP Snooping.
Command mode: Global configuration
no ip igmp snoop enable
Disables IGMP Snooping.
Command mode: Global configuration
Table 224 IGMP Snooping Configuration Commands
Command Syntax and Usage