Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 349
area-virtual-link <1-3> dead-interval <1-65535>
Configures the time period, in seconds, for which the router waits for hello packet from the
neighbor before declaring this neighbor down.
Command mode: Router OSPF3
area-virtual-link <1-3> transmit-delay <1-1800>
Configures the estimated time, in seconds, taken to transmit LS update packet over this
interface.
Command mode: Router OSPF3
area-virtual-link <1-3> retransmit-interval <1-1800>
Configures the interval, in seconds, between link-state advertisement (LSA) retransmissions
for adjacencies belonging to the OSPFv3 virtual link interface. The default value is five
seconds.
Command mode: Router OSPF3
area-virtual-link <1-3> neighbor-router <NBR router ID (IP address)>
Configures the router ID of the virtual neighbor. The default setting is 0.0.0.0
Command mode: Router OSPF3
area-virtual-link <1-3> enable
Enables OSPF virtual link.
Command mode: Router OSPF3
area-virtual-link <1-3> no enable
Disables OSPF virtual link.
Command mode: Router OSPF3
no area-virtual-link <1-3>
Deletes OSPF virtual link.
Command mode: Router OSPF3
show ipv6 ospf area-virtual-link
Displays the current OSPFv3 virtual link settings.
Command mode: All
Table 215 OSPFv3 Virtual Link Configuration Options
Command Syntax and Usage