Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 345
OSPFv3 AS-External Range Configuration
no area-range <1-16>
Deletes the OSPFv3 summary range.
Command mode: Router OSPF3
show ipv6 ospf area-range
Displays the current OSPFv3 summary range.
Command mode: All
Table 213 OSPFv3 AS_External Range Configuration Options
Command Syntax and Usage
summary-prefix <1-16> address <IPv6 address> <IPv6 prefix length (1-128)>
Configures the base IPv6 address and the subnet prefix length for the range.
Command mode: Router OSPF3
summary-prefix <1-16> area <area index (0-2)>
Configures the area index used by the switch.
Command mode: Router OSPF3
summary-prefix <1-16> aggregation-effect {allowAll|denyAll|
advertise|not-advertise}
Configures the aggregation effect, as follows:
 allowAll: If the area ID is 0.0.0.0, aggregated Type-5 LSAs are generated. Aggregated
Type-7 LSAs are generated in all the attached NSSAs for the range.
 denyAll: Type-5 and Type-7 LSAs are not generated.
 advertise: If the area ID is 0.0.0.0, aggregated Type-5 LSAs are generated. For other
area IDs, aggregated Type-7 LSAs are generated in the NSSA area.
 not-advertise: If the area ID is 0.0.0.0, Type-5 LSAs are not generated, while all
NSSA LSAs within the range are cleared and aggregated Type-7 LSAs are generated for
all NSSAs. For other area IDs, aggregated Type-7 LSAs are not generated in the NSSA
area.
Command mode: Router OSPF3
Table 212 OSPFv3 Summary Range Configuration Options
Command Syntax and Usage