Technical data

BLADEOS 6.3 Command Reference
340
 Chapter 4: Configuration Commands BMD00186-B, April 2010
exit-overflow-interval <0-4294967295>
Configures the number of seconds that a router takes to exit Overflow State. The default value
is 0 (zero).
Command mode: Router OSPF3
reference-bandwidth <0-4294967295>
Configures the reference bandwidth, in kilobits per second, used to calculate the default
interface metric. The default value is 100,000.
Command mode: Router OSPF3
timers spf {<SPF delay (0-65535)>} {<SPF hold time (0-65535)>}
Configures the number of seconds that SPF calculation is delayed after a topology change
message is received. The default value is 5.
Configures the number of seconds between SPF calculations. The default value is 10.
Command mode: Router OSPF3
router-id <IPv4 address>
Defines the router ID.
Command mode: Router OSPF3
[no] nssaAsbrDfRtTrans
Enables or disables setting of the P-bit in the default Type 7 LSA generated by an NSSA
internal ASBR. The default setting is disabled.
Command mode: Router OSPF3
enable
Enables OSPFv3 on the switch.
Command mode: Router OSPF3
Table 210 OSPFv3 Configuration Commands
Command Syntax and Usage