Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 333
OSPF Interface Configuration
Table 205 OSPF Interface Configuration Commands
Command Syntax and Usage
ip ospf area <0-2>
Configures the OSPF area index.
Command mode: Interface IP
ip ospf priority <0-255>
Configures the priority value for the G8124’s OSPF interfaces.
A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that
the interface cannot be used as Designated Router (DR) or Backup Designated Router (BDR).
Command mode: Interface IP
ip ospf cost <1-65535>
Configures cost set for the selected path—preferred or backup. Usually the cost is inversely
proportional to the bandwidth of the interface. Low cost indicates high bandwidth.
Command mode: Interface IP
ip ospf hello-interval <1-65535>
Configures the interval, in seconds, between the hello packets for the interfaces.
Command mode: Interface IP
ip ospf dead-interval <1-65535>
Configures the health parameters of a hello packet, in seconds, before declaring a silent
router to be down.
Command mode: Interface IP
ip ospf transit-delay <1-3600>
Configures the transit delay in seconds.
Command mode: Interface IP
ip ospf retransmit-interval <1-3600>
Configures the retransmit interval in seconds.
Command mode: Interface IP