Technical data

BLADEOS 6.3 Command Reference
326
 Chapter 4: Configuration Commands BMD00186-B, April 2010
[no] ip rip multicast-updates
Enables or disables multicast updates of the routing table (using address 224.0.0.9). The
default value is enabled.
Command mode: Interface IP
[no] ip rip default-action {listen|supply|both}
When enabled, the switch accepts RIP default routes from other routers, but gives them lower
priority than configured default gateways. When disabled, the switch rejects RIP default
routes. The default value is none.
Command mode: Interface IP
[no] ip rip metric [<1-15>]
Configures the route metric, which indicates the relative distance to the destination. The
default value is 1.
Command mode: Interface IP
[no] ip rip authentication type [<password>]
Configures the authentication type. The default is none.
Command mode: Interface IP
[no] ip rip authentication key <password>
Configures the authentication key password.
Command mode: Interface IP
ip rip enable
Enables this RIP interface.
Command mode: Interface IP
no ip rip enable
Disables this RIP interface.
Command mode: Interface IP
show interface ip <interface number> rip
Displays the current RIP configuration.
Command mode: All
Table 200 RIP Interface Commands
Command Syntax and Usage