Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 325
Routing Information Protocol Interface Configuration
The RIP Interface commands are used for configuring Routing Information Protocol parameters for
the selected interface.
Note – Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
Table 200 RIP Interface Commands
Command Syntax and Usage
ip rip version {1|2|both}
Configures the RIP version used by this interface. The default value is version 2.
Command mode: Interface IP
[no] ip rip supply
When enabled, the switch supplies routes to other routers. The default value is enabled.
Command mode: Interface IP
[no] ip rip listen
When enabled, the switch learns routes from other routers. The default value is enabled.
Command mode: Interface IP
[no] ip rip poison
When enabled, the switch uses split horizon with poisoned reverse. When disabled, the switch
uses only split horizon. The default value is disabled.
Command mode: Interface IP
[no] ip rip split-horizon
Enables or disables split horizon. The default value is enabled.
Command mode: Interface IP
[no] ip rip triggered
Enables or disables Triggered Updates. Triggered Updates are used to speed convergence.
When enabled, Triggered Updates force a router to send update messages immediately, even
if it is not yet time for the update message. The default value is enabled.
Command mode: Interface IP