Technical data

BLADEOS 6.3 Command Reference
320
 Chapter 4: Configuration Commands BMD00186-B, April 2010
Routing Map Configuration
Note – The map number (1-32) represents the routing map you wish to configure.
Routing maps control and modify routing information.
Table 196 Routing Map Configuration Commands
Command Syntax and Usage
route-map <1-32>
Enter route map configuration mode.
Command mode: Route map
[no] access-list <1-8>
Configures the Access List.
Command mode: Route map
For more information, see page 322.
[no] as-path-list <1-8>
Configures the Autonomous System (AS) Filter.
Command mode: Route map
For more information, see page 323.
[no] as-path-preference <1-65535>
Sets the AS path preference of the matched route. You can configure up to three path
preferences.
Command mode: Route map
[no] local-preference <0-4294967294>
Sets the local preference of the matched route, which affects both inbound and outbound
directions. The path with the higher preference is preferred.
Command mode: Route map
[no] metric <1-4294967294>
Sets the metric of the matched route.
Command mode: Route map