Technical data

BLADEOS 6.3 Command Reference
316
 Chapter 4: Configuration Commands BMD00186-B, April 2010
ARP Configuration
Address Resolution Protocol (ARP) is the TCP/IP protocol that resides within the Internet layer.
ARP resolves a physical address from an IP address. ARP queries machines on the local network
for their physical addresses. ARP also maintains IP to physical address pairs in its cache memory. In
any IP communication, the ARP cache is consulted to see if the IP address of the computer or the
router is present in the ARP cache. Then the corresponding physical address is used to send a
packet.
no ip mroute <IP address> <VLAN number> adminkey <1-65535>|none]
Removes a static multicast route. The destination address, VLAN, and LACP admin key of
the route to remove must be specified.
Command mode: Global configuration
show ip mroute
Displays the current IP multicast routes.
Command mode: All except User EXEC
Table 192 ARP Configuration Commands
Command Syntax and Usage
ip arp rearp <2-120>
Defines re-ARP period in minutes. You can set this duration between 2 and 120 minutes.
Command mode: Global configuration
show ip arp
Displays the current ARP configurations.
Command mode: All except User EXEC
Table 191 IP Multicast Route Configuration Commands
Command Syntax and Usage