Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 315
IP Multicast Route Configuration
The following table describes the IP Multicast (IPMC) route commands. Before you can add an
IPMC route, IGMP must be turned on, IGMP Snooping must be enabled, and the required VLANs
must be added to IGMP Snooping.
Table 191 IP Multicast Route Configuration Commands
Command Syntax and Usage
ip mroute <IPMC destination> <VLAN number> <port alias or number>|none]
Adds a static multicast route. The destination address, VLAN, and member port of the route
must be specified.
Command mode: Global configuration
no ip mroute <IPMC destination> <VLAN number> <port alias or number>|none]
Removes a static multicast route. The destination address, VLAN, and member port of the
route to remove must be specified.
Command mode: Global configuration
ip mroute <IP address> <VLAN number> portchannel <trunk group number>|
none]
Adds a static multicast route. The destination address, VLAN, and member trunk group of the
route must be specified.
Command mode: Global configuration
no ip mroute <IP address> <VLAN number> portchannel <trunk group number>|
none]
Removes a static multicast route. The destination address, VLAN, and member trunk group
of the route to remove must be specified.
Command mode: Global configuration
ip mroute <IP address> <VLAN number> adminkey <1-65535>|none]
Adds a static multicast route. The destination address, VLAN, and LACP admin key of the
route must be specified.
Command mode: Global configuration