Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 309
Default Gateway Configuration
The switch can be configured with up to four IPv4 gateways, as follows:
 Gateway 1 and Gateway 2: data traffic
 Gateway 3: Management port A
 Gateway 4: Management port B
This option is disabled by default.
Table 188 Default Gateway commands
Command Syntax and Usage
ip gateway <1-4> address <IP address>
Configures the IP address of the default IP gateway using dotted decimal notation.
Command mode: Global configuration
ip gateway <1-4> interval <0-60>
The switch pings the default gateway to verify that it’s up. This command sets the time
between health checks. The range is from 0 to 60 seconds. The default is 2 seconds.
Command mode: Global configuration
ip gateway <1-4> retry <1-120>
Sets the number of failed health check attempts required before declaring this default gateway
inoperative. The range is from 1 to 120 attempts. The default is 8 attempts.
Command mode: Global configuration
[no] ip gateway <1-4> arp-health-check
Enables or disables Address Resolution Protocol (ARP) health checks. The default setting is
disabled. The arp option does not apply to management gateways.
Command mode: Global configuration
ip gateway <1-4> enable
Enables the gateway for use.
Command mode: Global configuration
no ip gateway <1-4> enable
Disables the gateway.
Command mode: Global configuration