Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 307
IPv6 Neighbor Discovery Configuration
The following table describes the IPv6 Neighbor Discovery Configuration commands.
Table 187 IPv6 Neighbor Discovery Configuration commands
Command Syntax and Usage
[no] ipv6 nd suppress-ra
Enables or disables IPv6 Router Advertisements on the interface. The default setting is
disabled (suppress Router Advertisements).
Command mode: Interface IP
[no] ipv6 nd managed-config
Enables or disables the managed address configuration flag of the interface. When enabled,
the host IP address can be set automatically through DHCP.
The default setting is disabled.
Command mode: Interface IP
[no] ipv6 nd other-config
Enables or disables the other stateful configuration flag, which allows the interface to use
DHCP for other stateful configuration. The default setting is disabled.
Command mode: Interface IP
ipv6 nd ra-lifetime <0-9000>
Configures the IPv6 Router Advertisement lifetime interval. The RA lifetime interval must be
greater than or equal to the RA maximum interval (advint).
The default value is 1800 seconds.
Command mode: Interface IP
[no] ipv6 nd dad-attempts <1-10>
Configures the maximum number of duplicate address detection attempts.
The default value is 1.
Command mode: Interface IP
[no] ipv6 nd reachable-time <1-3600>
Configures the advertised reachability time. The default value is 30 seconds.
Command mode: Interface IP