Technical data

BLADEOS 6.3 Command Reference
290
 Chapter 4: Configuration Commands BMD00186-B, April 2010
LACP Port Configuration
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
selected port.
Table 174 Link Aggregation Control Protocol Commands
Command Syntax and Usage
lacp mode {off|active|passive}
Set the LACP mode for this port, as follows:
 off
Turn LACP off for this port. You can use this port to manually configure a static trunk.
The default value is off.
 active
Turn LACP on and set this port to active. Active ports initiate LACPDUs.
 passive
Turn LACP on and set this port to passive. Passive ports do not initiate LACPDUs, but
respond to LACPDUs from active ports.
Command mode: Interface port
lacp priority <1-65535>
Sets the priority value for the selected port. Lower numbers provide higher priority. The
default value is 32768.
Command mode: Interface port
lacp key <1-65535>
Set the admin key for this port. Only ports with the same admin key and oper key (operational
state generated internally) can form a LACP trunk group.
Command mode: Interface port
show interface port <port alias or number> lacp
Displays the current LACP configuration for this port.
Command mode: All