Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 289
Link Aggregation Control Protocol Configuration
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
G8124.
Table 173 Link Aggregation Control Protocol Commands
Command Syntax and Usage
lacp system-priority <1-65535>
Defines the priority value for the G8124. Lower numbers provide higher priority. The default
value is 32768.
Command mode: Global configuration
lacp timeout {short|long}
Defines the timeout period before invalidating LACP data from a remote partner. Choose
short (3 seconds) or long (90 seconds). The default value is long.
Note: It is recommended that you use a timeout value of long, to reduce LACPDU
processing. If your G8124’s CPU utilization rate remains at 100% for periods of 90 seconds
or more, consider using static trunks instead of LACP.
Command mode: Global configuration
no lacp <1-65535>
Deletes a selected LACP trunk, based on its admin key. This command is equivalent to
disabling LACP on each of the ports configured with the same admin key.
Command mode: Global configuration
show lacp
Display current LACP configuration.
Command mode: All