Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 281
LLDP Configuration
Use the following commands to configure Link Layer Detection Protocol (LLDP).
clear mac-address-table multicast {all|mac <MAC address>|
vlan <VLAN number>|port <port alias or number>}
Clears static multicast entries.
Command mode: Global configuration
show mac-address-table
Display current FDB configuration.
Command mode: All except User EXEC
Table 167 LLDP commands
Command Syntax and Usage
lldp refresh-interval <5-32768>
Configures the message transmission interval, in seconds. The default value is 30.
Command mode: Global configuration
lldp holdtime-multiplier <2-10>
Configures the message hold time multiplier. The hold time is configured as a multiple of the
message transmission interval.
The default value is 4.
Command mode: Global configuration
lldp trap-notification-interval <1-3600>
Configures the trap notification interval, in seconds. The default value is 5.
Command mode: Global configuration
lldp transmission-delay <1-8192>
Configures the transmission delay interval. The transmit delay timer represents the minimum
time permitted between successive LLDP transmissions on a port.
The default value is 2.
Command mode: Global configuration
Table 166 FDB configuration commands
Command Syntax and Usage