Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 277
When configuring STG bridge parameters, the following formulas must be used:
 2*(fwd-1) >
mxage
 2*(hello+1) <
mxage
spanning-tree stp <STG number> bridge forward-delay <4-30>
Configures the bridge forward delay parameter. The forward delay parameter specifies the
amount of time that a bridge port has to wait before it changes from the listening state to the
learning state and from the learning state to the forwarding state. The range is 4 to 30 seconds,
and the default is 15 seconds.
This command does not apply to MSTP
Command mode: Global configuration
show spanning-tree stp <STG number> bridge
Displays the current bridge STG parameters.
Command mode: All
Table 163 Bridge Spanning Tree Configuration Commands
Command Syntax and Usage