Technical data

BLADEOS 6.3 Command Reference
266
 Chapter 4: Configuration Commands BMD00186-B, April 2010
Active Multipath Configuration
Use the following commands to configure Active Multipath (AMP) for the G8124.
spanning-tree uplinkfast max-update-rate <10-200>
Configures the station update rate. The default value is 40.
Command mode: Global configuration
show layer2
Displays current Layer 2 parameters.
Command mode: All
Table 156 AMP Configuration Options
Command Syntax and Usage
[no] active-multipath aggr-portchannel lacp <1-65535>
Configures an LACP admin key to be used as the AMP Aggregator link. LACP trunks formed
with this admin key will be used to link the two AMP Aggregators.
Note: This command does not apply to AMP Access switches.
Command mode: Global configuration
[no] active-multipath aggr-port <port alias or number>
Configures a port to be used as the AMP Aggregator link.
Note: This command does not apply to AMP Access switches.
Command mode: Global configuration
[no] active-multipath aggr-portchannel <trunk number>
Configures a trunk to be used as the AMP Aggregator link.
Note: This command does not apply to AMP Access switches.
Command mode: Global configuration
Table 155 Layer 2 Configuration Commands
Command Syntax and Usage