Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 251
DSCP Configuration
These commands map the DiffServ Code Point (DSCP) value of incoming packets to a new value or
to an 802.1p priority value.
Table 141 DSCP Configuration Commands
Command Syntax and Usage
qos dscp dscp-mapping <DSCP (0-63)> <new DSCP (0-63)>
Maps the initial DiffServ Code Point (DSCP) value to a new value. Enter the DSCP value
(0-63) of incoming packets, followed by the new value.
Command mode: Global configuration
qos dscp dot1p-mapping <DSCP (0-63)> <priority (0-7)>
Maps the DiffServ Code point value to an 802.1p priority value. Enter the DSCP value,
followed by the corresponding 802.1p value.
Command mode: Global configuration
qos dscp re-marking
Turns on DSCP re-marking globally.
Command mode: Global configuration
no qos dscp re-marking
Turns off DSCP re-marking globally.
Command mode: Global configuration
show qos dscp
Displays the current DSCP parameters.
Command mode: All except User EXEC