Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 249
Port Spanning Tree Configuration
show interface port <port alias or number> access-control
Displays current ACL QoS parameters.
Command mode: All
Table 139 Port STP Options
Command Syntax and Usage
[no] spanning-tree edge
Enables or disables this port as an edge port. An edge port is not connected to a bridge, and
can begin forwarding traffic as soon as the link is up. Configure server ports as edge ports
(enabled).
Note: After you configure the port as an edge port, you must disable the port and then
re-enable the port for the change to take effect.
Command mode: Interface port
[no] spanning-tree link-type p2p|shared
Defines the type of link connected to the port, as follows:
 no: Configures the port to detect the link type, and automatically match its settings.
 p2p: Configures the port for Point-To-Point protocol.
 shared: Configures the port to connect to a shared medium (usually a hub).
The default link type is auto.
Command mode: Interface port
show interface port {<port alias or number>}
Displays current port configuration parameters.
Command mode: All
Table 138 ACL/QoS Configuration Commands
Command Syntax and Usage