Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 245
Port Link Configuration
Use these commands to set flow control for the port link.
Table 135 Port Link Configuration Commands
Command Syntax and Usage
speed {10|100|1000|10000|auto}
Sets the link speed. Some options are not valid on all ports. The choices include:
 10 Mbps
 100 Mbps
 1000 Mbps
 any (auto negotiate port speed)
Note: Data ports are fixed at 10000 Mbps.
Command mode: Interface port
duplex {full|half|any}
Sets the operating mode. The choices include:
 “Any,” for auto negotiation (default)
 Half-duplex
 Full-duplex
Note: Data ports are fixed at full duplex.
Command mode: Interface port
[no] flowcontrol {receive|send|both}
Sets the flow control. The choices include:
 Receive flow control
 Transmit flow control
 Both receive and transmit flow control (default)
 No flow control
Command mode: Interface port
[no] auto
Turns auto-negotiation on or off.
Note: Data ports are fixed at 10000 Mbps, and cannot be set to auto-negotiate, unless a 1 Gb
SFP transceiver is used.