Technical data

BLADEOS 6.3 Command Reference
242
 Chapter 4: Configuration Commands BMD00186-B, April 2010
Port Configuration
Use the Port Configuration commands to configure settings for interface ports.
Table 133 Port Configuration Commands
Command Syntax and Usage
interface port <port alias or number>
Enter Interface port mode.
Command mode: Global configuration
dot1p <0-7>
Configures the port’s 802.1p priority level.
Command mode: Interface port
pvid <VLAN number>
Sets the default VLAN number which will be used to forward frames which are not VLAN
tagged. The default number is 1 for non-management ports.
Command mode: Interface port
name <1-64 characters>
Sets a name for the port. The assigned port name appears next to the port number on some
information and statistics screens. The default is set to None.
Command mode: Interface port
[no] bpdu-guard
Enables or disables BPDU guard, to avoid Spanning-Tree loops on ports with Port Fast
Forwarding enabled, or ports configured as edge ports.
Command mode: Interface port
[no] dscp-marking
Enables or disables DSCP re-marking on a port.
Command mode: Interface port
[no] tagging
Disables or enables VLAN tagging for this port. The default setting is disabled.
Command mode: Interface port