Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 233
Management Network Configuration
These commands are used to define IP address ranges which are allowed to access the switch for
management purposes.
[no] access tsbbi enable
Enables or disables Telnet/SSH configuration through the Browser-Based Interface (BBI).
Command mode: Global configuration
[no] access userbbi enable
Enables or disables user configuration access through the Browser-Based Interface (BBI).
Command mode: Global configuration
show access
Displays the current system access parameters.
Command mode: All
Table 124 Management Network Configuration Commands
Command Syntax and Usage
access management-network <IP address> <IP mask>
Adds a defined network through which switch access is allowed through Telnet, SNMP, RIP,
or the BLADEOS browser-based interface. A range of IP addresses is produced when used
with a network mask address. Specify an IP address and mask address in dotted-decimal
notation.
Note: If you configure the management network without including the switch interfaces, the
configuration causes the Firewall Load Balancing health checks to fail and creates a
“Network Down” state on the network.
Command mode: Global configuration
no access management-network <IP address> <IP mask>
Removes a defined network, which consists of a management network address and a
management network mask address.
Command mode: Global configuration
Table 123 System Access Configuration Commands
Command Syntax and Usage