Technical data

BLADEOS 6.3 Command Reference
232
 Chapter 4: Configuration Commands BMD00186-B, April 2010
System Access Configuration
Table 123 System Access Configuration Commands
Command Syntax and Usage
access user administrator-password
access user operator-password
access user user-password
Allows you to change the password. You must enter the current password in use for
validation.
Command Mode: Global configuration
[no] access http enable
Enables or disables HTTP (Web) access to the Browser-Based Interface. It is enabled by
default.
Command mode: Global configuration
[default] access http port [<port alias or number>]
Sets the switch port used for serving switch Web content. The default is HTTP port 80.
Command mode: Global configuration
[no] access snmp {read-only|read-write}
Disables or provides read-only/write-read SNMP access.
Command mode: Global configuration
[no] access telnet enable
Enables or disables Telnet access. This command is enabled by default.
Command mode: Global configuration
[default] access telnet port [<1-65535>]
Sets an optional Telnet server port number for cases where the server listens for Telnet
sessions on a non-standard port.
Command mode: Global configuration
[default] access tftp-port [<1-65535>]
Sets the TFTP port for the switch. The default is port 69.
Command mode: Global configuration