Technical data

BLADEOS 6.3 Command Reference
228
 Chapter 4: Configuration Commands BMD00186-B, April 2010
SNMPv3 Target Address Table Configuration
These commands are used to configure the target transport entry. The configured entry is stored in
the target address table list in the SNMP engine. This table of transport addresses is used in the
generation of SNMP messages.
Table 120 Target Address Table Configuration Commands
Command Syntax and Usage
snmp-server target-address <1-16> address <IP address>
name <1-32 characters>
Allows you to configure the locally arbitrary, but unique identifier, target address name
associated with this entry.
Command mode: Global configuration
snmp-server target-address <1-16> name <1-32 characters>
address <transport IP address>
Configures a transport IPv4 or IPv6 address that can be used in the generation of SNMP traps.
IPv6 addresses are not displayed in the configuration, but they do receive traps.
Command mode: Global configuration
snmp-server target-address <1-16> port <port alias or number>
Allows you to configure a transport address port that can be used in the generation of SNMP
traps.
Command mode: Global configuration
snmp-server target-address <1-16> taglist <1-255 characters>
Allows you to configure a list of tags that are used to select target addresses for a particular
operation.
Command mode: Global configuration
snmp-server target-address <1-16> parameters-name <1-32 characters>
Defines the name as defined in the following command on page 229:
snmp-server target-parameters <1-16> name <1-32 characters>
Command mode: Global configuration