Technical data

BLADEOS 6.3 Command Reference
218
 Chapter 4: Configuration Commands BMD00186-B, April 2010
snmp-server read-community <1-32 characters>
Configures the SNMP read community string. The read community string controls SNMP
“get” access to the switch. It can have a maximum of 32 characters. The default read
community string is public.
Command mode: Global configuration
snmp-server write-community <1-32 characters>
Configures the SNMP write community string. The write community string controls SNMP
“set” and “get” access to the switch. It can have a maximum of 32 characters. The default
write community string is private.
Command mode: Global configuration
snmp-server timeout <1-30>
Sets the timeout value for the SNMP state machine, in minutes.
Command mode: Global configuration
[no] snmp-server authentication-trap
Enables or disables the use of the system authentication trap facility. The default setting is
disabled.
Command mode: Global configuration
[no] snmp-server link-trap
Enables or disables the sending of SNMP link up and link down traps. The default setting is
enabled.
Command mode: Global configuration
snmp-server trap-src-if <interface number>
Configures the source interface for SNMP traps. The default value is interface 1.
To send traps through the management port A, specify interface 127.
To send traps through management port B, specify interface 128.
Command mode: Global configuration
snmp-server host <trap host IP address> <trap host community string>
Adds a trap host server.
Command mode: Global configuration
Table 113 System SNMP Commands
Command Syntax and Usage