Operation Manual

DR750S-1CH
15
6
Turn on the engine. The BlackVue dashcam will power up and start recording. Video les are stored on the microSD card. When the
microSD card lls up, the newest video les will start to replace the oldest video les (called loop recording) – so you will always
have the most recent video les.
7
Turn o the engine. The dashcam will automatically stop recording and power down. To record in parking mode while the engine is
o please install a Power Magic Battery Pack (sold separately) or a Power Magic Pro (sold separately). A Power Magic Pro powers
your dashcam when the engine is o by hardwiring it to the automotive battery. A low voltage power cut-o function and a parking
mode timer protect the automotive battery from discharge.
Note
y
Up to 50 event recordings (impact, manual) can be locked from being overwritten. By default, this feature is disabled. You can
enable it from rmware settings and choose to either overwrite them with new event les when the event le storage is full
or lock the 50 event les and save the new event les in loop recording storage. Please note that formatting the microSD card
deletes all the recordings including the locked event les.
y
The recording LED blinks while recording (default setting) and the GPS LED is on when a GPS signal is received. There are 4
recording modes: Normal, Event, Parking and Manual. The dashcam starts recording in normal mode, switches to event mode
when an impact is detected, and switches to parking mode if the vehicle is stationary for 5 minutes. Touching the proximity
sensor turns on/o audio recording or triggers manual recording depending on the rmware settings.
y
When you run the dashcam for the rst time the rmware is automatically loaded onto the microSD card. After the rmware has
been loaded onto the microSD card you can customize settings using BlackVue Viewer on a computer.