Operation Manual

12
BLACKVUE
6
Use the pry tool to lift the edges of the windshield trim/molding and tuck in the power cord. You can also make use of the cable clips
to neatly arrange the power cord.
Power cord
7
Plug the power cord into the cigarette lighter socket and the dashcam.
8
The camera will turn on automatically when the engine is started (check that the recording LED is blinking orange and the GPS LED
is on).
9
Turn on the engine. The BlackVue dashcam will power up and start recording. Video les are stored on the microSD card. When the
microSD card lls up, the newest video les will start to replace the oldest video les (called loop recording) - so you will always
have the most recent video les.
Note
y
The recording LED blinks while recording (default setting) and the GPS LED is on when a GPS signal is received. There are 3
recording modes: Normal, Event and Parking. The dashcam starts recording in normal mode, switches to event mode when an
impact is detected, and switches to parking mode if the vehicle is stationary for 10 minutes.
y
When you run the dashcam for the rst time the rmware is automatically loaded onto the microSD card. After the rmware
has been loaded onto the microSD card you can customize settings using BlackVue Viewer on a computer.
10
Turn o the engine. The dashcam will automatically stop recording and power down. To record in parking mode while the engine
is o please install a Power Magic Pro (sold separately). A Power Magic Pro powers your dashcam when the engine is o by
hardwiring it to the automotive battery. A low voltage power cut-o function and a parking mode timer protect the automotive
battery from discharge.