Operation Manual

8
BlackVue Usage
Installation
Insert the Micro SD Card into the BlackVue
1.
Insert the Micro SD card into the
Micro SD slot in the same direction
as shown in the picture.
Press the card again to remove
it. While doing this, be careful so
that the Micro SD card won't pop
out.
Tu r n of f the Bl ackVu e b e fore
inserting the card into it.
Cautions for Using the Micro SD Card
y
Insert/remove the Micro SD card with the BlackVue off.
(Check to see if all the LEDs on the BlackVue are off.)
y
Do not remove the Micro SD card while saving data on the card or reading data from
it. This may cause data loss and product malfunction.
y
Check the data stored on the Micro SD card to see if the product is working properly.
y
We recommend you use the genuine memory cards provided by Pittasoft. We do not
take any responsibility for problems caused by the use of other memory cards.
y
The Micro SD card is consumable. Replace it with a new one after a longtime use.
y
Make sure to store important data on another storage medium. We do not take any
responsibility for data loss caused by user's fault.
BlackVue_Eng_0726.indd 8 2012-07-26 �� 4:00:47