Instructions / Assembly

8
If “growing” bubbles appear do not use or move
the LP tank. Contact an LP gas supplier or your
re department.
LP Tank Exchange
• Many retailers that sell grills offer you the option of
replacing your empty LP tank through an exchange
service. Use only those reputable exchange companies
that inspect, precision ll, test and certify their tanks.
Exchange your tank only for an OPD safety
feature-equipped tank as described in the “LP Tank”
section of this manual.
• Always keep new and exchanged LP tanks in upright
position during use, transit or storage.
• Leak test new and exchanged LP tanks BEFORE
connecting to grill.
• Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result
in leakage of propane.
LP Tank Leak Test For Your Safety
• Leak test must be repeated each time LP tank is
exchanged or relled.
• Do not smoke during leak test.
• Do not use an open ame to check for gas leaks.
• The Rec Stove must be leak tested outdoors in a
well-ventilated area, away from ignition sources
such as gas red or electrical appliances.
• During leak test, keep Rec Stove away from open
ames or sparks.
• Use a clean paintbrush and a 50/50 mild soap and
water solution. Brush soapy solution onto areas
indicated in gure below. Leaks are
indicated by growing bubbles.
Connecting Regulator To The LP Tank
1. Place the LP tank on the right side of the Single Burner
Rec Stove between the supporting right side legs.
2. Turn all control knobs to the OFF position.
3. Turn LP tank OFF by turning OPD hand wheel
clockwise to a full stop.
4. Remove the protective cap from LP tank valve. Always
use cap and strap supplied with valve.
Do not insert a POL transport
plug (plastic part with external
threads) into the Type 1 tank
valve outlet. It will defeat the
Safety Relief Valve feature.
5. Hold regulator and insert nipple into LP tank valve.
Hand-tighten the coupling nut, holding regulator in
a straight line with LP tank valve so as not to cross
thread the connection.
Do not use household cleaning agents. Damage
to gas valve/hose/regulator components can result.
OPD Hand Wheel
Off Clockwise
Safety Relief Valve
Type 1 outlet with
thread on outside
Strap
Cap
Nipple has to be centered
into the LP tank valve