Instructions / Assembly

16
LIGHTING INSTRUCTION
Lighting The BLACKSTONE Single Burner Rec
Stove
Do not lean over the grill when lighting.
Read instructions before lighting.
1. Turn the control knobs to OFF position.
2. Open valve at tank fully by turning
counterclockwise.
3. Push in the control knob to start gas owing.
4. Turn the control knob counterclockwise to
activate the piezoelectric starter. You will hear a
snap and the starter will emit a spark at the end
of the ignition needle next to the burner.
5. If ignition does not occur, turn the burner control
off, wait a few seconds and repeat the lighting
procedure or refer to match lighting instructions
below.
Match Lighting (lighting hook located above right
knob)
If your appliance has a griddle top, grill box, or stock
pot on it, they must be removed rst. If ignition does
not occur in 5 seconds, turn the burner control(s) off,
wait 5 minutes and repeat the lighting procedure.
1. Place match into match holder(hanging from side
panel of griddle). Light match: then light burner by
placing match next to the holes in the burner.
2. Push in and turn burner knob to the HIGH
position, depending on match light hole selected.
Be sure burner lights and stays lit.