Instructions / Assembly

11
Burner Flame Check
Light burner, rotate knob from high to low. You
should see a smaller ame in low position than
seen on high. Perform burner ame check on side
burner, also. Always check ame prior to each use.
If only low ame is seen refer to “Sudden drop or
low ame” in the Troubleshooting.
Turning the Single Burner Rec Stove Off
Turn knob to the OFF position. Turn LP
cylinder OFF by turning hand-wheel clockwise to a
full stop.
Valve Check
Important: Make sure gas is off at LP cylinder
before checking valves. Knobs lock in OFF
position. To check valve, rst push in knob and
release, knob should spring back. If knob does not
spring back, replace valve assembly
before using the Rec Stove. Turn knob to low
position then turn back to OFF position. Valve
should turn smoothly.
Hose Check
Clean and inspect the hose before each use of the
appliance. If there is evidence of abrasion, wear,
cuts or leaks, the hose must be replaced prior to
the appliance being put into operation. Use only
identical replacement part valve/hose/regulator
as specied in the Parts List of this Use and Care
Guide.
General Cleaning
• Do not mistake brown or black accumulation
of grease and smoke for paint. Interiors of
gas ovens are not painted at the factory (and
should never be painted). Apply a strong
solution of detergent and water or use an oven
cleaner with scrub brush on insides of oven lid
and bottom. Rinse and allow to
completely air dry. Do not apply a caustic
griddle/oven cleaner to painted surfaces.
• Plastic parts: Wash with warm soapy water and
wipe dry. Do not use Citrisol, abrasive
cleaners, de-greasers or a concentrated oven
cleaner on plastic parts. Damage to and failure
of parts can result.
• Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water.
Wipe dry with a soft nonabrasive cloth.
• Baked-on grease deposits may require the use
of an abrasive plastic cleaning pad. Use gently
to avoid damage. Do not use abrasive pad on
areas with graphics.
Storing Your Product
Store in dry location.
• When an LP cylinder is connected to
the Rec Stove, store outdoors in a well-
ventilated space and out of reach of children.
• Cover Rec Stove if stored outdoors. Choose
from a variety of covers offered by Blackstone
Products.
• Store Rec Stove indoors ONLY if LP cylinder
is turned off and disconnected, removed from
Rec Stove and stored outdoors.
• When removing BLACKSTONE Single Burner
Rec Stove from storage, follow “Cleaning the
Burner Assembly” instructions before
starting the Rec Stove.