Instructions / Assembly

10
Turn controls and gas source or tank
OFF when not in use.
If ignition does NOT occur in 5 seconds,
turn the burner controls OFF, wait 5
minutes and repeat the lighting
procedure. If the burner does not ignite
with the valve open, gas will continue to
ow out of the burner and could
accidently ignite with risk of injury.
Disconnecting Regulator From The LP Tank
1.
LP tank must be properly secured onto Single
Burner Rec Stove. (Refer to assembly section.)
2. Turn all control knobs to the OFF position.
3. Turn LP tank OFF by turning OPD hand wheel
clockwise to a full stop.
4. Remove the connector valve by unscrewing the
coupling nut.
Safety Tips
1. Before opening LP cylinder valve, check the
coupling nut for tightness.
2. When Rec Stove is not in use, turn off control
knob and LP cylinder valve.
3. Never move BLACKSTONE Single Burner Rec
Stove while in operation or still hot.
4. Use long-handled barbecue utensils and oven
mitts to avoid burns and splatters.
5. Keep unit at least 36” away from walls, buildings,
vehicles or other structures when in use.
6. Clean your Rec Stove often, preferably after
each cookout. If a bristle brush is used to clean
the cooking surface, ensure no loose bristles
remain on cooking surfaces prior to cooking.
7. If you notice grease or other hot material
dripping from BLACKSTONE Single Burner Rec
Stove onto valve, hose or regulator, turn off gas
supply at once. Determine the cause, correct it,
then clean and inspect valve, hose and regulator
before continuing. Perform a leak test.
8. Keep ventilation openings in cylinder enclosure
free and clear of debris.
9. The regulator may make a humming or whistling
noise during operation. This will not affect safety
or use of BLACKSTONE Single Burner Rec
Stove.
10. If you have a problem see the “Troubleshooting
Section”.
11. If the regulator frosts, turn off Rec Stove and
LP cylinder valve immediately. This indicates a
problem with the cylinder and it should not be
used on any product. Return to supplier!
Match-Lighting
Do not lean over BLACKSTONE Single Burner Rec
Stove while lighting. Make sure there is no leakage at
the tube. Insure that valve knob and regulator knob
are in the “OFF” position. If your appliance has a
griddle top, grill box, or stock pot on it, they must be
removed rst. If ignition does not occur in 5 seconds,
turn the burner control(s) off, wait 5 minutes and
repeat the lighting procedure.
1. Place match into match holder(hanging from side
panel of griddle). Light match: then light burner by
placing match next to the holes in the burner.
2. Push in and turn burner knob to the HIGH
position, depending on match light hole selected.
Be sure burner lights and stays lit.