User`s manual

Cerebus® User’s Manual
Revision 13.00 / LB-0028 Page 48
Digital Oscilloscope
The oscilloscope app is capable of displaying up to two traces of analog input channels on the screen at a very high
resolution of 0.1 ms/div.
Figure 42 - Digital Oscilloscope View
o Channel Enable: The user can enable up to two channels per instance of the oscilloscope.
o Channel Selection: Select any channel from the drop down menu.
o Color Selection: Allows the user to select a color for either of the traces.
o Settings: It will open up the Properties window for each channel. Note: a sampling rate other than <none> needs to be
selected or the trace will not appear on the screen.
o Invert: Selecting this option will invert the trace for a given channel.
o Delay: This option will display the channel 2 trace with a delay compared to channel 1.
o Trace Amplitude: Modifying the sliders for each channel will change the signal amplitude. The top trace changes the
range and the lower slider is used to choose a value within the given range.
o Time/Frequency selection: Selecting time will operate the oscilloscope in the time domain. Selecting frequency will
operate the oscilloscope in the frequency domain.
o Time Resolution: Modifying the sliders will change the resolution of the signal. The upper sliders change the range of
resolution and the lower slider is used to choose a value within the given range.
o Trigger Type: choose between Auto, Normal and Single.
 Auto: The trace will display continuous signal until the trace crosses the trigger level. When the trace crosses
the trigger level, it will momentarily pause until either the trace crosses the trigger level again, or after a short
pause, will resume displaying the continuous signal.