Specifications

Note) Refer to “How to Order Bowl Assembly” on page 63.
Note) Sight glass is indicated in the figure for easy understanding
of component parts. However, it differs from the actual
construction. Refer to dimensions on pages 7 through to 9
for details.
Construction
Maximum Air Flow Model Selection
AMG150C to 550C, AMG650
No.
4
Description
Applicable
model
Except option F
For option F
Material
Resin,
others
Element
assembly
AMG150C
AMG-EL150
AMG-EL150-F
AMG250C
AMG-EL250
AMG-EL250-F
AMG350C
AMG-EL350
AMG-EL350-F
AMG450C
Model
AMG-EL450
AMG-EL450-F
AMG550C
AMG-EL550
AMG-EL550-F
AMG650
AMG-EL650
—
AMG850
AMG-EL850
—
∗ Element assembly: With gasket (1 pc.) and O-ring (1 pc.)
∗ Refer to back page 6 for replacement of auto drain.
∗ Element assemblies for Made to Order (X12, X15, X20, X26) are same as those for standard (see the above table).
Replacement Parts
AMG850
Select a model in accordance with the following procedure taking the
inlet pressure and the max. air flow rate into consideration.
(Example) Inlet pressure: 0.6 MPa
Max. air flow rate: 5 m
3
/min (ANR)
1. Obtain the intersecting point A of inlet pressure and max. air flow
rate in the graph.
2. The AMG650 is obtained when the max. flow line is above the in-
terecting point A in the graph.
OUTIN
OUTIN
q
r
w
e
No.
2
3
1
Description
Material Note
Aluminum die-casted
∗
Aluminum die-casted
Tempered glass
Chrome treated
Epoxy coating on
inner surface
—
Housing
Body
Sight glass
Component Parts
∗ The AMG850 is aluminum casted.
Note) Make sure to select a model that has the max. flow line above
the obtained intersecting point. With a model that has the max.
flow line below the obtained intersecting point, the flow rate will
be exceeded, thus leading to a problem such as being unable to
satisfy the specifications.
Max. air flow rate (m
3
/min (ANR))
Inlet pressure (MPa)
6
Water Separator Series AMG