Instruction manual

Getting Started
16
Preserving Blanking Data or VANC
This feature lets you use up to 3 video lines at the top of a captured movie file to store any 3 lines from
vertical blanking. This allows 3 line timecode, VITC (vertical interval test signals) subtitle info or any other
VANC data to be preserved during capture. These lines are then inserted back into the video blanking when
the file is played back.
To preserve VANC data, select the VANC and 3:2 Pulldown tab and tick the On check box for video line 1, 2
or 3 depending on how many blanking lines you want to capture.
Video file line 1 needs to be enabled for lines 2 and 3 to work.
Because these lines can be passed to the application, a developer could write software to read the VANC
data and use it for various purposes, e.g. 3-line timecode and audio chasing, or other uses.
An example of VANC data is 3-line timecode, which uses lines 18, 19, and 20 in NTSC or lines 19, 20 and
21 in PAL. 3-line timecode, as used in AATON™ equipped telecine suites, featuring audio timecode and
keycode information along with the normal timecode numbers.
How to use Lookup Tables in Multibridge
Multibridge Eclipse and Multibridge Pro can use either 1D or 3D LUTs during playback.
Under the Settings tab, set the Frame output switch to “Last Played Frame” and then restart the computer.
Open your preferred video software application, play some video, open the Blackmagic system preferences
and click on the Processing tab. The last played frame of video will remain on your broadcast monitor.
Ensure that output processing is set to "Off" and then click on the corresponding Lookup Table button.
After selecting the Enable Lookup Tables checkbox, the lookup table interface can be adjusted using a
method similar to the Curves feature in Adobe Photoshop
™
.
Changes are saved to the Blackmagic system preferences by clicking the OK button. Lookup tables can
be reset to original values by clicking the Reset Unity button. Lookup table processing can be disabled by
deselecting the Enable Lookup Tables checkbox. Lookup tables can be imported and exported using the
Load Table and Save Table buttons.
VANC preferences.
Enable Lookup Tables.