Instruction manual

Getting Started
14
Remove Field Jitter
When interlaced video is paused on old CRT monitors, eliminate field flicker by only displaying a single field.
We do not recommend using this option with modern flat screens.
Frame output switch
If you have switched out of a video application and video is no longer being played, this setting determines
whether your Blackmagic video hardware will output black or the last played frame of video or an extended
desktop.
If you are adjusting LUTs on some Blackmagic models, set this option to Last Played Frame so you can
observe the effect of any adjustment to LUTs.
The extended desktop feature is supported on some Blackmagic models. Enabling or disabling the feature
requires a restart of the computer. It's important that you set the extended desktop to the same standard
as your video capture and playback, or you will get slower switching between capture and playback modes,
as the monitors need to re-lock.
HDMI monitoring formats in 3D mode
When monitoring 3D stereoscopic video, select a format which is supported by your HDMI display: Frame
Packing, Side by Side, Line by Line, Top and Bottom, Left Eye or Right Eye.
Reference Output Timing
A reference signal may also be known as genlock, black burst, house sync or tri-sync. If you have reference
connected but your picture is rolling, adjust the "Set reference output timing" until the picture locks and is
no longer rolling on the Blackmagic video output.
Video Output Behavior.
Frame output switch
HDMI 3D monitoring formats
Genlock timing adjustment.