Instruction manual

Understanding the LCD Menus
54
Timecode Menu
A wide range of options are available for defining the processor’s response to incoming timecode or
for generation of new timecode. This flexibility allows you to pass the incoming timecode to the output,
strip incoming timecode completely or regenerate timecode based on your project’s needs.
The Timecode menu, shown below, permits selection of the desired timecode mode of operation and
provides access to registers for setting specific timecode data.
Please note that Timecode processing is TURNED OFF as the default setting for the processor. It
should be turned ON via one of the selections in the Mode menu below, if needed.
While timecode detection is usually automatic in the Teranex Processor, the timecode Setup menu
page allows you to manually define the line on which timecode will be detected on the input or inserted
in the output. The Setup menu also permits selection of drop frame or non drop frame operation in
format conversions where drop frame timecode is applicable.
Main Menu
Back
Setup
Ancillary
Data
Noise
Reduction
Video
1
Main Menu
Ancillary Data
Back
Video
Index
Timecode
Closed
Caption
2
Ancillary Data
Spanish
Italian
German
French
English
Select Language
Back
Service 2
Language
Service 1
Language
Service 2
Source
Analog
Out Line
Analog
In Line
CC
Enable
3
Closed Caption /
Service 2 Language
Main Menu
Back
Setup
Ancillary
Data
Noise
Reduction
Video
1
Main Menu
Ancillary Data
Back
Video
Index
Timecode
Closed
Caption
2
Ancillary Data
Timecode
Back
Next
Start
Source
Setup
Start
Prev
Set
Timecode
Mode
Select
3
Timecode / Mode Select