Instruction manual

20
Teranex Processor Settings
 Quad HD SDI in the Teranex Express supports Ultra HD output formats in the square
division method as outlined in SMPTE 435-1 (4x1080p). To provide the required four SDI
outputs, Teranex Express utilizes the two SDI outputs and repurposes the two SDI Input Loop
connectors as outputs. The quad HD outputs are assigned as follows:
– SDI Output A: Sub image 1
– SDI Output B: Sub image 2
– SDI Input Loop A: Sub image 3
– SDI Input Loop B: Sub image 4
Proc Amp Menu Settings
Use the Proc Amp Menu to adjust gain, saturation, hue, sharpness and more. The Proc Amp Menu is
accessed via the Video menu. A quicker way to reach this menu is by pressing one of the Proc Amp
Video buttons on the control panel. Turn the rotary knob to adjust your settings.
After adjustment, the associated button will illuminate white to indicate a non-default setting. To reset
to its default setting, select the parameter via the Proc Amp Menu or control panel button and then
push the rotary knob. To easily return all parameters to their default settings, go to the Proc Amp Menu
and select Reset All.
 Gain – Range: -60 to +60. Default: 0
 Saturate (Saturation) – Range: -60 to +60. Default: 0
 Black – Range: -30 to +30. Default: 0
 Hue – Range: -179 to +180. Default: 0 degrees
 R-Y and B-Y – Range: -200 to +200. Default: 0
 Sharp (Sharpness) – Range: -50 to +50. Default: 0
 Reset All – Resets all Proc Amp parameters to their default values
Proc Amp
0
Sharp
Hue
Black
Reset
All
R-Y / B-Y
Saturate
Gain
Proc Amp Menu>Gain
Video
Advanced
Test
Patterns
Proc
Amp
Aspect
Setup
Clip
Color
Video Menu>Proc Amp
Quad HD
Use this for UHD
and Video Walls
Out A Out B
Loop A Loop B
SDI
Output
No Video
Input
Video Menu>Setup>SDI
Output>Quad HD