Instruction manual

Teranex Processor Settings
39
3D Menu Settings
The 3D menu is available only in the Teranex 3D Processor model. This menu enables the dual internal
processors of the Teranex 3D Processor for format or frame rate conversion of stereoscopic inputs and
for conversion of 2D sources into simulated 3D outputs.
3D Mode
In the 3D Mode menu, “Off” implies normal 2D processing. The following selections are available to
enable 3D processing:
 Convert – This mode enables processing of stereoscopic left and right eye inputs, which
may be input via the SDI or HDMI inputs. This mode will also synchronize the incoming
stereoscopic signals, which means that two non-synchronous inputs may be input to the
Teranex 3D Processor and the outputs will be synchronized.
– Connect your Left and Right Eye signals to SDI Input A and B, respectively.
 2D to 3D – This mode enables the 2D to 3D conversion algorithm. Any 2D video signal may
be converted into a simulated 3D output.
– If you’re using an SDI input, connect your 2D source to SDI Input A.
– When 2D to 3D is selected, the Intensity and Depth buttons will become available.
Descriptions for these settings are provided a bit later in this manual.
 3D Align – This mode enables the 3D alignment tools, including image flip, horizontal and
vertical positioning, axial rotation and toe-in.
– Connect your Left and Right Eye signals to SDI Input A and B, respectively.
Main Menu
Audio Reference
3D
Ancillary
Data
Noise
Reduction
Video
System
Setup
Main Menu>3D
2D to 3D
3D Align
Convert
Off
3D
Camera
Align
Depth
Intensity
Output
Input
3D Mode
3D Menu>3D Mode
3D Align
2D to 3D
Convert
Off
3D
Camera
Align
Depth
Intensity
Output
Input
3D Mode
3D Menu>3D Mode>
2D to 3D
3D Align
2D to 3D
Convert
Off
3D
Camera
Align
Depth
Intensity
Output
Input
3D Mode
Main Menu>3D>3D Mode>
3D Align
3D Align
2D to 3D
Convert
Off
3D
Camera
Align
Depth
Intensity
Output
Input
3D Mode
3D Menu>3D Mode>
3D Convert