Instruction manual

Teranex Processor Settings
36
DHCP Menu
The DHCP menu enables or disables the assignment of an IP address to the chassis using Dynamic Host
Configuration Protocol (DHCP). You can press the DHCP soft button or turn the rotary encoder to turn
DHCP ON or OFF. If you change this setting, press the “Save and Restart” button to power cycle the
chassis and establish the new IP address.
 ON – The Teranex Processor will accept an IP address assigned by your network router.
 OFF – The previous Static IP address of the unit will be used if one was previously assigned.
If you press the IP button with DHCP ON and see an IP address of 0.0.0.0, this indicates that the
processor was unsuccessful in obtaining an IP address from the DHCP server. Please check your
Ethernet network connections.
Factory Reset
Select Factory Reset to restore conversion setup settings to their factory defaults. The following settings
will not be affected:
 Presets.
 Output video settings, e.g., Format, Frame, Rate.
 Aspect selection; however, any adjustable aspect ratio settings will be reset to their
default values.
 Ethernet IP address settings.
Reference Menu Settings
The Reference menu lets you synchronize your video output to an input video source or external reference.
 Input – Selects the current input video source as the reference.
 External – Selects the external reference (REF) input.
Teranex auto-detects a valid reference source, but it must be compatible with the output format. The
table on the following page shows which reference signals are acceptable for each output video format
and frame rate.
System Setup>Factory Reset
System Setup
Factory
Reset
Ethernet
Press Reset to restore
factory settings, or Cancel
to abort.
Reset all settings
to factory default?
ResetCancel
Setup Menu>Ethernet>
DHCP Menu
Ethernet
IP
Prev Next
Gateway
DHCP
Off
On
Subnet
Mask
Save and
Restart
Main Menu
Audio Reference
3D
Ancillary
Data
Noise
Reduction
System
Setup
Video
Main Menu>Reference
External
Input
Reference
Pixel
Offset
Line
Offset
Type
Reference Menu>Type