Instruction manual
Teranex Processor Settings
35
System Setup Menu Settings
The System Setup menu provides access to Ethernet and Factory Reset menus.
Ethernet Setup Menu
The Ethernet setup menu allows you to display the current settings and assign new settings for Static IP
address, Subnet address and IP Gateway. This menu also permits you to turn DHCP On or Off.
When DHCP is ON, the IP, Subnet Mask and Gateway menus will display the addresses currently assigned
to the chassis by the DHCP server. These values may not be adjusted unless DHCP is OFF.
IP Menu
To set a Static IP Address for the Teranex processor, DHCP must be OFF.
The IP menu will display a four-field register allowing you to enter specific IP address values. Adjust the
selection highlighted by the cursor by turning the rotary encoder. Use the Prev and Next buttons to move
the cursor to the left or right, respectively. If you change this setting, press the “Back” button, then press
the “Save and Restart” button to power cycle the chassis and establish the new setting.
Subnet Mask Menu
The Subnet Mask menu will display a four-field register allowing you to enter specific values. Adjust the
selection highlighted by the cursor by turning the rotary encoder. Use the Prev and Next buttons to move
the cursor left or right, respectively. If you change this setting, press the “Back” button, then press the
“Save and Restart” button to power cycle the chassis and establish the new setting.
Gateway Menu
The Gateway menu will display a four-field register allowing you to enter specific values. Adjust the
selection highlighted by the cursor by turning the rotary encoder. Use the Prev and Next buttons to
move the cursor left or right. To establish new settings, press the “Back” button, then“Save and Restart.
Your Teranex will power cycle and apply the new settings.
Main Menu
Audio Reference
3D
Ancillary
Data
Noise
Reduction
System
Setup
Video
Main Menu>System Setup System Setup
Menu>Ethernet
System Setup
Factory
Reset
Ethernet
System Setup
Menu>Ethernet>IP Menu
Ethernet
IP
Prev Next
Gateway
DHCP
192.168.10.50
Subnet
Mask
Save and
Restart
System Setup
Menu>Ethernet>Subnet
Mask Menu
Ethernet
IP
Prev Next
Gateway
DHCP
255.255.255.0
Subnet
Mask
Save and
Restart
System Setup
Menu>Ethernet>Gateway
Menu
Ethernet
IP
Prev Next
Gateway
DHCP
190.168.15.1
Subnet
Mask
Save and
Restart