Instruction manual

Teranex Processor Settings
32
Input Regen The Input Regen mode synchronizes the input timecode to the output timecode and
is often used when performing frame rate conversions, such as1080i50 to 1080i59.94.
Input Regen mode should only be used when your Teranex processor is locked to
your input video.
Drop frame and non drop frame modes are both supported in 23.98, 29.97 and 59.94
frame rates. However, in a conversion where the source timecode is drop frame
and the output format is non drop frame timecode, the output timecode will be
automatically converted to non drop frame.
Generate The timecode generator will generate free running output timecode appropriate for
the selected output format, even if timecode is not present on your video input signal.
Set Timecode
The Set Timecode menu options you will have are determined by the selection you
make in the Start Source menu.
Start Source = “Input”
If the Start Source menu is set to “Input,” the Set Timecode menu will show “Input”
as the Start Value for the generator. When you press the Start button, the generator
will capture the current input timecode value and use that value to start outputting
free running timecode. If no timecode is present on your input video source, the
generator will begin counting at 00:00:00:00.
Start Source = “Start Value”
If the Start Source menu is set to “Start Value,” the Set Timecode menu will display
an eight-character register that allows the entry of a specific starting value for the
generator. Turn the rotary encoder to adjust the timecode generator values and
use the Previous and Next buttons to move the cursor left or right. When you press
the “Start” button the timecode generator will immediately output timecode from
your Start Value entry.
Ancillary Data
Video
Index
Timecode
Closed
Caption
Ancillary Data Menu>
Timecode
Jam Sync
Generate
Input Regen
Input
Off
Timecode
Start
Start
Source
NextPrev
Setup
Timecode
Generator
Set
Timecode
Timecode Menu>Input
Regen
Start Value
Input
Timecode
Start
Start
Source
NextPrev
Setup
Timecode
Generator
Set
Timecode
Generate>Start Source
Jam Sync
Generate
Input Regen
Input
Off
Timecode
Start
Start
Source
NextPrev
Setup
Timecode
Generator
Set
Timecode
Timecode Menu>Generate
Start Value
00:00:00:00
Timecode
Start
Start
Source
NextPrev
Setup
Timecode
Generator
Set
Timecode
Set Timecode Menu. Use
the Rotary knob to set your
values, and the Previous and
Next buttons to move the
cursor left and right.