Instruction manual

Teranex Processor Settings
18
Aspect Fill
To define the color of the bars used in pillarbox and letterbox aspect ratios, adjust the Luminance, and
Cb and Cr chroma values using the rotary knob.
Zoom/Crop
Zoom/Crop is used to mask potential video disturbances that may appear at the top, bottom, left or
right edges of your source image. This is performed by trimming your conversion slightly. Turning Zoom/
Crop on will instantly zoom the converted image vertically by 3 lines and horizontally by 3 pixels, then
crop the image by the same amount. Zoom/Crop will not effect your adjustable aspect ratio settings.
Video Setup Menu
The Video Setup menu lets you select your analog video input and output. You can also set colorbars
or black video to be output when no input video is detected.
No Input Menu
Use this menu to select Black or Colorbars to be output when no video is detected. The default setting
is Black.
Analog Input Video Setup Menu
In the Teranex 2D and 3D Processors, this menu lets you set the analog video input type.
 Component – Sets the analog input BNC connections as component Y, R-Y and B-Y.
 Composite – Sets the analog Y/NTSC/PAL input BNC connector as composite.
 The default setting is Component.
Fill
64
Reset
All
Cr
Cb
Luma
Aspect Fill>Luma
On
Zoom Crop
Off
Zoom
Crop
Fill
Adjust
Aspect
Aspect Menu>Zoom/Crop
Video
Advanced
Test
Patterns
Proc
Amp
Aspect
Setup
Clip
Color
Video Menu>Setup
Colorbar 75%
Black
Setup
Video
Sampling
Analog
Output
Analog
Input
Dual Link
Output
No Input
Setup Menu>No Input
Aspect
Zoom
Crop
Fill
Adjust
Aspect
Aspect Menu>Aspect Fill
Composite
Component
Setup
Video
Sampling
Analog
Output
Analog
Input
Dual Link
Output
No Input
Setup Menu>Analog Input