Instruction manual

Getting Started

Installing the Software for Windows

Contents

The Blackmagic UltraScope software installer will install the following components for you:

 Blackmagic UltraScope drivers

 Blackmagic UltraScope application

Blackmagic UltraScope Software

Step 1. The CD supplied with Blackmagic UltraScope contains the UltraScope software. Before you

install, ensure you have the very latest driver. Visit www.blackmagicdesign.com/support

Step 2. Open the “Blackmagic UltraScope Installer” folder and run the “Blackmagic UltraScope

Installer” application.

Step 3. Near the end of the software installation process, the software will check the UltraScope

hardware to see what firmware the card contains. If the firmware version does not match the

software version, UltraScope will offer to update the firmware. This is automatic and all you

need to do is click Update to start the update. After the firmware has updated, click the Finish

button to exit the setup wizard.

Step 4. Finally, click Yes to restart your computer and to enable the new software driver.

UltraScope Setup Wizard.