Instruction manual

Getting Started

Installing the UltraScope card in your Windows PC

Blackmagic UltraScope installs into your computer in just the same way as any regular PCI Express card.

However the fiber optic module must be temporarily removed from the card before attempting to install

the card in a PCI Express slot. This is because the location of the protruding fiber optic module makes

it awkward to install the card in the PCI ports of many computer cases. Temporarily removing the fiber

optic module overcomes this obstacle to installation.

Remove the power plug from the back of your computer. This is a safety precaution before opening your

computer. Ensure that you are statically discharged by using an antistatic strap.

Remove the side cover of your computer to gain access to the PCIe slots.

Remove the metal port access cover and screw from the back of your computer.

Remove your UltraScope PCIe card from the protective static bag making sure you don’t touch the gold

connectors on the base of the card. These precautions should be taken when handling any PCI card.

Step 1. Remove the protective cap from the LC connector port of the fiber optic module. Don’t throw it

away as the protective cap will be needed to prevent dust if the LC connector port is exposed

when no fiber optic cables are connected.

Pull the wire tab outward to an angle of 90° to release the SFP module latch.

Step 2. Grip the main portion of the SFP module, between your thumb and forefinger, and pull it from

the SFP module port. Do not pull the wire tab as it might break and prevent the SFP module

from being removed.

Step 3. Install Blackmagic UltraScope in a suitable PCI Express slot in your computer, ensure that it

clicks firmly into place and secure the card with a screw.

Step 4. Replace the SFP module and push the wire tab back to its original position. If you are not ready

to connect fiber optic cables to the LC connector port, replace the protective cap.

The procedure for installing a graphics card is similar to the above.

Now replace the side cover of your computer. Reconnect the power and start up the computer.

Blackmagic UltraScope PCI Express card