Instruction manual

Developer Information
62
If loop mode is set, the playback loop will be between:
the "start" position and the end of timeline for play forward,
the "start" position and the start of timeline for play backward.
By default the deck will continue playing until the end of the timeline. The
“end” parameter may be used to halt playback at the frame before the
specified timecode:
play: end: {timecode}↵
If loop mode is set, the playback loop will be between:
the start of timeline and the "end" position for play forward,
the end of timeline and the "end" position for play backward.
Note that the "end" position must be:
beyond the current/or start position on timeline for play forward,
before the current/or start position on timeline for play backward.
The “duration” parameter may be used instead of the “end” parameter to
halt playback after a duration specified in timecode format:
play: duration: {timecode}↵
These three parameters are not compatible with the “single clip” parameter.
Stopping deck operation
The "stop" command instructs the deck to stop the current playback or capture:
stop↵
Changing timeline position
The "goto" command instructs the deck to switch to playback mode and
change its position within the timeline.
To go to the start of a specific clip:
goto: clip id: {Clip ID}↵
To move forward/back {count} clips from the current clip on the current
timeline:
goto: clip id: +/-{count}↵
Note that if the resultant clip id goes beyond the first or last clip on timeline,
it will be clamp at the first or last clip.