Instruction manual

Installation
7
Installing the HDMI bracket
The DeckLink HD Extreme 3D includes an HDMI bracket. After installing the DeckLink HD Extreme 3D card
in a x4 lane PCIe slot, you will need a spare slot to install the HDMI bracket. Some PCs include a double-
width graphics slot in the x16 lane slot. If you have a regular-width graphics card in this slot, you can install
the HDMI bracket in the spare port which would have been used by a double-width graphics card. If that
port is already occupied by a double-width graphics card, use a spare slot to install the HDMI bracket. If you
don’t need HDMI input and output, there is no necessity to install the HDMI bracket.
Some computer cases provide a PCI clamp which is designed to secure all PCI Express cards without the
need for screws. The clamp does not always firmly secure the HDMI bracket and so we have included 6
screws with your DeckLink HD Extreme 3D. Use these screws, in place of the PCI clamp, to firmly secure all
your PCI Express cards, port access covers and the HDMI bracket belonging to DeckLink HD Extreme 3D.
After installing and securing the HDMI bracket, loop the included HDMI cables around any other installed
cards and plug them into the rear of the DeckLink HD Extreme 3D card. HDMI input is the lower connector
and HDMI output is the upper connector. You may wish to secure any excess cable length by using a cable
tie to neatly hold it in place.
Note: Connecting audio and video cables to the DeckLink can be done at any time while the unit is
powered on or off. You can leave the PCI Express card in the computer when the PCI Express cable is
disconnected. It will then be ready to reconnect quickly when you need to use DeckLink as a capture
and playback device again.
Installing DeckLink Optical Fiber
DeckLink Optical Fiber installs in to your computer in just the same way as any other DeckLink card. However
the fiber optic module must be temporarily removed from the card before attempting to install the card
in a PCI Express slot. This is because the location of the protruding fiber optic module makes it awkward
to install the card in the PCI ports of many computer cases. Temporarily removing the fiber optic module
overcomes this obstacle to installation. The fiber optic module is a standard SFP transceiver module which
includes an LC connector port for attaching fiber optic cables. While other kinds of optical connectors exist,
the SMPTE standard for Optical Fiber SDI specifies that LC type optical fiber connectors be used and this
makes it easy for all compliant optical equipment to connect together.
Attach the supplied DeckLink breakout cable to the DeckLink card.
The DeckLink HD Extreme 3D card also includes a HDMI bracket
as pictured above.