Instruction manual

Third Party Applications

Adobe Premiere Pro

Audio

DeckLink features support for ASIO audio output drivers. This allows Premiere Pro to use DeckLink

as an ASIO audio output device. When you ﬁrst start your Premiere Pro project, make sure you select

DeckLink Audio. This can be conﬁgured through Edit > Preferences > Audio Hardware

You can also select the mix of the multi-channel audio from the Audio Output Mapping menu.

Export to Tape

To export to tape, select the sequence you require File > Export > Export to Tape

Insert editing requires an unbroken timecode over the full length of the project you’re laying to

tape. This is referred to as “blacking the tape”.

In assemble mode the tape needs only to be “blacked” until a point just beyond the start time of

the project. As assemble editing erases the tape ahead of the record heads, it should not be used

where other projects already exist on the tape after the out point of your edit.

When editing to tape, the software waits at the ﬁrst frame of your program for the deck to drop into

record at the predetermined timecode. At that exact moment, the program begins to play and the

edit is completed. Should you ﬁnd that either the ﬁrst frame of your program is repeated or lost

during the edit to tape procedure you will need to adjust the playback offset to bring the deck and

your computer into sync. You should only need to do this once with any combination of deck and

computer – and the setting will then stay correct.

Now, simply enter the desired in point and offsets if required, and click OK

Device Control

Selection of the Serial Device Control is conﬁgured via:

Edit > Preferences > Device Control

Set the Device Control to DeckLink Device Control. The Options button is disabled as these

settings are automatically detected and conﬁgured when you choose DeckLink Device Control.

Audio Output Mapping.

Export to Tape.

Device Control.